MOST EFFECTIVE RESULTS is in correct fitting

The only fashionable Posture Support, helps me look good and stand tall

Try this first and let us know. Here are the KEY difference to avoid the neck area showing.

Wear your BAX-U brace like a shirt.
1- Loosen the shoulder straps and move them up on top of your shoulders. (keep it loose)
2- Pull as low as possible on the back “T” support almost 2-4cm= 1″-2″ below your neck line. (so it doesn’t show under a T-shirt/ shirt, the lower you pull down the more adjust-ability you have on the shoulder area.)
3- Close the chest area.
4- Now the “Shoulder sustainability”:
A- Open the velcor of right shoulder with right hand.
B- Bring your elbow on same level as your shoulder,
C- Look up
D- Roll your elbow in half circle motion towards the back,
E- Pull on the shoulder adjustable velcor hook (rough end) about (2-3cm= 1″-1.5″)
F- Place/ close/ stick on top of the shoulder velcor loop (soft area on shoulder).
G- Feel about 25-30% shoulder retraction. Don’t go for a dramatic shift as the muscles will fatigue and it will not last long!

This correct wear will result in:
1- Keep the upper “V” away from your neck
2- Retract your shoulders
3- Allows your mid/lower back to act as a pivital point in moving you in better alignment and stronger muscles.

You should feel:
–Taller
–More straight
–Still have flexabilty of movement without slouching 🙂

Before and after, customer testimonial.

You the above is in a video that you can find on the site www.BAX-U.com: Go to ORDER NOW scroll to bottom page, and watch how I run thru the above steps.

I hope this helps, Please write back to me at drg@BAX-U.com with an update.

Sincerely
Dr.G